Step 1: Getting the Materials for this instructable you will need. Fig. Optical Mouse Sensor; Optical Finger Navigation; Optical Tracking Sensor; OBJECT MOTION SENSING. test the pencil in the space where the scroll wheel had been and make sure it will fit. . Some simple image recognition allo. The optical sensor on the mouse needs to be elevated a couple of millimeters from the surface for the best input and response. The chip only has 8 pins and 6 of them need to be controlled. So, the process to deconstruct my mouse was as follows (also see pictures): Remove rubber adhesive feed covering screws (at the rear) and clips (at the front. or register. Hello friends, I'm trying to use a mouse sensor (ADNS-5700 H3MB) to retrieve coordinates for positioning, but i'm having problems on. Step 2: Opening the Mice. Optical mouse sensors are essentially self-contained cameras that track movement and make it available to a host. We don't care about XY_LED (wired up to the red LED that shines on the mousing surface) and REGO. . The "Slide Controller" is an Option Pak that connects to the underside of a Nintendo DS, making the entire device act as an optical mouse. Apr 06, 2011 · #1 Hello, I am a REAL newbie into electronics. If you do not have one at home or work, use a small amount of alcohol rub on a rag, and gently wipe down the optical sensor. Benefit from great features such as ambidextrous design and stay at your peak creativity without emptying your wallet. I will start a post that collects nifty mouse sensor hacks. Detach and flip the mouse. The optical sensor in PC mice In the case of optical mice, these do not emit any type of light, so the mouse is usually accompanied by a light emitter, usually an LED light,. 75K subscribers Grab the frame buffer from an optical mouse. 2). an optical laptop mouse (I had two laying around, amazon has same decent ones for about 8$) a pencil (a chopstick would work as would a small stick cut down to size) a small screwdriver and a knife or small saw. ls. .